Rubber & Plastics

Rubber & Plastics


Plastic

As any plastics professional knows, molds and the plastic coming into them are heated to extreme temperatures. This generates a gas that liquefies and sticks to the mold and can be tough to remove. Additionally, vents at the end-of-fill get clogged from the buildup of gases. These vents need to remain open and unobstructed in order to help keep the mold clean. This gas can damage the mold and effect product quality.

In addition to being very labor intensive, traditional cleaning such as abrasive blasting, wiping with chemicals or solvents, and wire brushing, requires production to stop so molds can be taken out and disassembled. With dry ice blasting molds can be cleaned while they are hot and still in the press.This greatly reduces, and often eliminates downtime due to cleaning. Because of this equipment can be cleaned more frequently, which helps keep vents open. The media, dry ice pellets, are non-abrasive, so there is no damage to the molds.

Extrusion screw and nozzle cleaning is often tedious and can require long production stops. Dry ice blasting reduces this downtime by allowing screws to be cleaned right out of the barrel. The heat from the barrel helps enhance the thermal effect caused by the dry ice pellets. The contaminant becomes more brittle, thus easier to remove.

 

Rubber

Rubber parts can stick to the mold during removal, which increases cycle time. In some cases, mold build-up can lead to over-packing, which in turn can cause internal strains to the tooling. One of the challenges that molders face is mold fouling or soiling because of the rubber off-gassing in the cavities at the vent area and the subsequent productivity loss when molds are taken out of the press for cleaning.

Dry ice blasting is used to clean rubber molds for manufacturers of gaskets, o-rings, shoes, and many other products. Dry ice blasting reduces potential damage to the molds from removing them from the press and reinstalling them.

Dry ice blasting utilizes a non-abrasive cleaning of tire mold sidewalls without the removal of the mold from the press or the creation of a secondary waste stream. The benefits inherent to dry ice blast tire mold cleaning are derived from establishing a manual “sidewall touch-up/cleaning” maintenance routine that keeps the operator’s exposure and risk to a minimum, (and installing an automated, robotic dry ice blast cleaning system for total mold cleaning when the molds are pulled out of the presses for scheduled press maintenance).

A tire manufacturer could realize over a million dollars per year in savings from labor and mold rework cost reductions, increased mold and press up-time, increased tire production and a reduced scrap tire rate. Dry ice blasting generally allows a tire manufacturer to produce blemish free tires for an entire production run, or until normal press maintenance requires that the mold be removed.

Designed By Bigintmedia.com | All Rights Reserved.